Example of installation

The installation is an easy processplished by technically talented persons.

  1. With the door open wait for five minutes before install the device. During this time the vehicle is checking the electronic systems of the car through the can bus system.
  2. Remove the accelerator pedal. In most vehicles there are 1-3 bolts that keep the pedal in place.
  3. Once you have removed the accelerator pedal ,locate the ECU connector on the accelerator pedal.
  4. Disconnect the OEM connector from the pedal.
  5. Connect Sprint Booster on the pedal.
  6. Connect the OEM connector on the Sprint Booster.
  7. Make sure all connections are firmly in place (both OEM connector and Sprint Booster are properly hooked)
  8. Put the pedal back to it's initial position.
  9. Finished

 

diesel tuning